A wholehouse heat recovery system with up to 94% energy efficiency. An easily accessible heat recovery cube protected by two removableISO 45% Coarse (G3) Filters. Two Lo-Carbon Energy Saving EC/DC fans ensure long life (typically over double the life of AC motors) and lowest possible energy use. Fully insulated construction with built-in condensation drain. Lo-Carbon Kinetic Plus E meets the latest requirements of the Building Regulations Approved Document F for wholehouse system ventilation. The Lo-Carbon Kinetic Plus E model has two adjustable speeds, normal and boost. On the front of the unit is the controller that can be used to preset the speeds to any required performance, up to 111l/s (400m3/hr) 150Pa. Offering ‘Close Control’ to prevent over ventilating. Acoustically lined - low noise levels from only 20dB(A) @ 3m. For scenarios where noise is a critical issue, an Acoustic Enclosure is available to reduce breakout noise and the Acoustic Top Box will reduce in-duct noise at key frequencies. Left or Right Hand Installation Units are supplied right handed with duct spigots to outside on the right hand side. These can be reversed onsite by simply removing the control panel, rotating the unit 180 degrees and reattaching the control panel. Spigot Options The combination of spigot options allows installation in confined locations. If vertical and horizontal connections are required on the same outlet/inlet, additional spigots can be supplied. Filter Check An LED on the control panel illuminates at 6 month intervals to remind users to check and clean the filters. Frost Protection The Kinetic E range benefits from an automatic frost protection system to prevent the heat recovery cell freezing in very cold weather, while at the same time maintaining ventilation. Control Options There are two LS (Switched Live) inputs allowing the unit to be connected to a number of sensors and controllers such as Timespan, Ambient Response Humidistat. One of the LS connections also benefits from a ‘Delay-On’ feature which prevents the unit boosting unnecessarily. Switching on the control panel allows activation of the Summer Mode.
ISO ePM10 50% (M5) Filter 1 Pack. Formally known as M5, this filter will remove smaller particles, including pollen.
cart: Array ( [444201] => Array ( [stock] => 38 [price] => 41.88 [desc] => FILTER M5 SENT KINETIC PLUS B/HIGH FLOW/PLUS E [net_weight] => 0.3 [gross_weight] => 0.3 [rPartNum] => 444201 [iPartNum] => 444201 ) )
SKU:
A wholehouse heat recovery system with up to 94% energy efficiency. An easily accessible heat recovery cube protected by two removableISO 45% Coarse (G3) Filters. Two Lo-Carbon Energy Saving EC/DC fans ensure long life (typically over double the life of AC motors) and lowest possible energy use. Fully insulated construction with built-in condensation drain. Lo-Carbon Kinetic Plus E meets the latest requirements of the Building Regulations Approved Document F for wholehouse system ventilation. The Lo-Carbon Kinetic Plus E model has two adjustable speeds, normal and boost. On the front of the unit is the controller that can be used to preset the speeds to any required performance, up to 111l/s (400m3/hr) 150Pa. Offering ‘Close Control’ to prevent over ventilating. Acoustically lined - low noise levels from only 20dB(A) @ 3m. For scenarios where noise is a critical issue, an Acoustic Enclosure is available to reduce breakout noise and the Acoustic Top Box will reduce in-duct noise at key frequencies. Left or Right Hand Installation Units are supplied right handed with duct spigots to outside on the right hand side. These can be reversed onsite by simply removing the control panel, rotating the unit 180 degrees and reattaching the control panel. Spigot Options The combination of spigot options allows installation in confined locations. If vertical and horizontal connections are required on the same outlet/inlet, additional spigots can be supplied. Filter Check An LED on the control panel illuminates at 6 month intervals to remind users to check and clean the filters. Frost Protection The Kinetic E range benefits from an automatic frost protection system to prevent the heat recovery cell freezing in very cold weather, while at the same time maintaining ventilation. Control Options There are two LS (Switched Live) inputs allowing the unit to be connected to a number of sensors and controllers such as Timespan, Ambient Response Humidistat. One of the LS connections also benefits from a ‘Delay-On’ feature which prevents the unit boosting unnecessarily. Switching on the control panel allows activation of the Summer Mode.
Kinetic plus filter
Sentinel Kinetic Advance Standard Filter -  ISO 45% Course  (G3) Filter 2 Pack. Formally known as G3, this filter will provide the minimum required filtration.
cart: Array ( [403702] => Array ( [stock] => 88 [price] => 33.07 [desc] => FILTER G3 SENT KINETIC PLUS B/HIGH FLOW/PLUS E 2 PACK [net_weight] => 0.55 [gross_weight] => 0.55 [rPartNum] => 403702 [iPartNum] => 403702 ) )
SKU: