HR200V
Overview
A ducted heat recovery unit for internal rooms. Self-contained and includes two mixed flow speed controllable fans. Using a high performance, polymeric heat exchange cube together with two power fans, the HR200V can boast a temperature efficiency of up to 70%. Low speed for trickle ventilation mode.
Specially designed to provide ventilation for small internal rooms in commercial, educational and leisure applications. Ventilation is achieved by using nominal 150mm diameter flexible ducting. The unit is completely self contained and includes two mixed flow speed controllable fans plus a high efficiency polymeric heat exchanger.
Installation
HR200V is designed for mounting in a cupboard, a ceiling void or above a suspended ceiling. Four spigots are provided for simple connection to 150mm flexible ducting. When passing through an unheated area insulated ducting should be used.
Performance
HR200V to be used with a 150VA Transformer for maximum controllabilty
| Motor Speed | 1 | 2 | 3 | |
|---|---|---|---|---|
| Voltage | 140 | 160 | 240 | |
| Watts Volume m³/h (FID) | 51.5 | 60.0 | 110 | |
| Supply | 48.3 | 55.8 | 70.3 | |
| Extract | 139 | 187 | 241 |
Dimensions
Weight: 5.6kg
| Sound Power Spectrum (Max Speed) | 63Hz | 125Hz | 250Hz | 500Hz | 1KHz | 2KHz | 4KHz | 8KHz | dB(A) @ 3m |
|---|---|---|---|---|---|---|---|---|---|
| 62 | 65 | 70 | 62 | 52 | 51 | 46 | 46 | 43 |
| Power Consumption | |
|---|---|
| Maximum | 110.0W |
Typical Specifications
Supply and install a HR200V Wholehouse heat recovery unit as manufactured by:
Vent-Axia Clean Air Systems
Fleming Way
Crawley
West Sussex
RH10 9YX
| Performance: | m³/h | l/s |
| Max ventilation rate (FID) | ||
| Supply | 253.0 | 70.28 |
| Extract | 371.0 | 103.06 |
| N° speed settings | Refer to type of control |
Efficiency: The unit should retain up to 70% of the temperature differential of out going air.
Heat exchanger: should be of a multi plate cross-flow type constructed out of a polymeric plastic with ultra sonic welded joints.
Motor: should be a 240V 50Hz A/C with sleeve bearings, greased for life. It shall operate up to an ambient temperature of 40°C and be fitted with a manual reset thermal overload protective device.
Fan: The 2-N° polymeric fan impellers should be of a dynamically balanced mixed flow type.
Controls: The unit should be operated via either an Electronic Speed Controller or Trickle Boost Switch/Sensors via 150VA Transformer.
Ducting spigots: The unit should have 4-N° 150mm Ø x 50mm spigots. (Can be converted to flat ducting).
Filter: not fitted.
Condensation: the outlet provided should be 22mm Ø located on the underside of the unit.
Construction: The unit outer case should be a rigid ABS moulding. The external grille should be a cream coloured ABS moulding. The spigot plates should be black vacuum formed PVC.
Mains electrical supply: 230VAC 50Hz.
Complies to the following approvals/directives: CE.
[^Top of page]
