shadow
Vent-Axia

Print Page Extension Sleeve - EXT100

Prices and stock levels correct at the time of printing (02/09/10 18:28)

For installation in walls from 280mm to 500mm thick. Supplied with white ABS plastic external grille.

Stock Ref No: 370419
60 in stock

This product is part of the HR100W/HR100WH range

Range Overview:

The Vent-Axia HR100W range is designed for continuous operation providing up to 70% Heat Recovery. Effectively controlling internal relative humidity. The Vent-Axia HR100WH unit come complete with
integral humidity sensor and controls condensation and reduces mould.

Fresh pre-warmed air from the outside is continuously provided to the room with simultaneous extraction of stale, moist air.

An integral heat exchanger transfers heat from the outgoing stale air to the fresh air supply, raising the temperature of the fresh air and most importantly reducing the Relative Humidity of the supply air to the room.

The HR100WH has a two speed motor which provides for constant low rate
ventilation automatically switching to boost speed on rising humidity level of approximately 70% relative humidity at 20°C. This level can easily be adjusted by removing the front cover and heat exchanger to reveal the adjustment spindle.

Typical Installation

HR100W/HR100WH Typical Installation

Extract Performance

m³/h
Intake Performance

m³/h
Watts Sounds Levels

dB(A) @ 3m
Boost Trickle Boost Trickle Boost Trickle Boost Trickle
73 43 69 38 31 12 30 20

HR100W units require a 240mm x 160mm hole. The unit should be fitted so that it slopes towards the outside (nominal 1°) to assist in-built condensate drainage.

The telescopic flange (adjustable to fit walls 220mm to 280mm thick) covers cutting marks and provides a surface for forming a seal with the external wall surface. An extension sleeve is available for thicker walls up to 500mm. (Stock Ref. 370419)

Maintenance

Filters should be replaced every six months or as conditions necessitate. Replacement filters can be purchased in packs of four. (Stock Ref. No. 37 03 78).The heat exchanger should be washed in warm soapy water every twelve months or as conditions necessitate. Access to the filter and heat exchanger is via two screws on the internal grille.

HR100W/HR100WH Filters

Power Consumption

 Trickle    12.0W  
 Boost    31.0W
Click for more information about the range

Downloads for the HR100W/HR100WH range

Other models in the range

HR100W
HR100WH
Model: 370419Extension Sleeve - EXT100
Model: 370378Filter Pack HR100W/WH